Calibrations
If you have any question pleaseCall: (800) 252.2401
NH: (603) 424.2401
sales@reticles.com
Glass diameter must be specified when ordering
For an additional cost Klarmann Rulings, Inc. can perform calibrations on site traceable to N.I.S.T.
Our Calibration Department is Accredited to ISO/IEC 17025.
"General requirements for the competence of testing and calibration laboratories."
Actual readings of calibrated items have an overall accuracy of +/- 0.00002"/0.0004mm with a best measurement uncertainty of +/- 0.00003"/0.0007mm.
Instructions For Mounting Reticles In Eyepieces
Finding the correct position in the eyepiece for the reticle is usually quite simple.
- In most occulars a field stop is located in the occulars focal plane.
- To locate this field stop unscrew the bottom retainer of the eyepiece.
- Remove the retaining ring and existing reticle if applicable.
- Carefully clean the new reticle and insert it against the field stop.
- Be sure to position the reticle so that the image is viewed correctly through the eyepiece.
- Install the retaining ring against the reticle snugly. Before screwing the eyepiece back together ensure that the reticle is free from dust or debris.
- The reticle can be focused in the normal manner by turning the top of the eyepiece.
- Some eyepieces do not require a retaining ring, and still others require cementing the reticle in position. In any instance the general instructions above apply.
- Some eyepieces are not equipped with field stops.
- In this case you will need to contact the microscope manufacturer and ask that they supply you with the proper insert in conjunction with your particular microscope.
